Installation Instructions - Gliderol Glidermatic GRD+ Installation Instructions And Owner's Manual

Installation Instructions

The GRD+ unit may be retrofitted to any roller doors including non Gliderol doors and also it does not
require any disassembly of the door during installation.
The GRD+ unit may be retrofitted to either side of a roller door. Selection of the desired side may be
determined by the available room, location of power and general installation.
In some circumstances the wall bracket may need to be relocated if the distance between the side
edge of the bracket and face of the drum wheel is greater than 130mm or less than 70mm (110mm for
Gliderol doors drumwheel recessed at 75mm from edge of curtain).
Furthermore the face of the drum wheel should not be recessed more than 75mm from the edge of
the curtain.
The door must be in good working conditions, adjustments to spring tension may be required.
These instructions are to be read in conjunction with Roller Door Installation instructions.
Please note:-
THE FOLLOWING INSTRUCTIONS FOR FIXING OF THE DRIVE UNIT ASSEMBLY TO THE DOOR
ARE FOR A RIGHT HAND INSTALLATION. (Refer to Fig 1-8).
a) Check the door U-bolt is securely tightened on the LEFT hand side of the door.
b) Raise the door and tie a rope around the centre to secure the roll.
Fig: 2
c) Support the right hand end of the door with a suitable prop, e.g. step ladder and soft padding to
protect the door surface (Fig. 2)
Glidermatic GRD+ Installation Instructions & owner's manual Page 3