Gliderol Glidermatic GRD+ Installation Instructions And Owner's Manual page 4

STOP WARNING: DO NOT ALLOW CHILDREN/PEOPLE AROUND THE DOOR WHEN PROPPED.
SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE CAN RESULT FROM FAILURE TO FOLLOW
THIS WARNING.
d) Carefully loosen and remove the right hand spindle 'U' bolt
e) Make sure the door supporting prop is secure. While the door is supported remove the right hand
wall mount bracket.(Fig. 3)
f) Slide the GRD drive unit on to the spindle of the door.
Fig: 3
g) Locate the engaging fork on the drive unit with drum wheel spoke. Please ensure the unit forks
are fully engaged into the spoke of the drum wheel.
Note: In the event of very tight side-room where the unit can't be slide through the bottom control
unit of the GRD+ operator can be separated and fit back again upon completion of installation. To
separate the Control unit remove the light lens cover and undo the two screws and lift the control
unit cover (fig: 3a) and now you can access the two bolts and unscrew them to separate the control
unit(fig: 3b). Undo the motor connection wires and hall IC cable from the circuit board. The control
unit can alos be mounted on the wall in which case a motor wire extension loom is required.
Glidermatic GRD+ Installation Instructions & owner's manual
Replace picture Lid
removed and
showing the 2 bolts
Replace picture
Showing Bottom
part and top part
separate.
Fig: 3a
Fig: 3b
Fig: 3c
Page 4