Table of Contents
Advertisement
5
Click Browse.
6
Select the shared folder for remote replication, then click OK.
Note: This folder is used by Amazon S3. Files are not added to the selected folder and the amount of used space
does not increase.
7
Enter the bucket name, access key ID, and secret access key of the Amazon S3 bucket, then click OK.
8
Amazon S3 is now enabled.
Notes:
• Amazon S3 is not compatible with Buffalo TurboPC EX. Uninstall TurboPC EX before using Amazon S3.
• Enter the path from the "Target Folder" field in a browser window to access the files saved to Amazon S3.
• To use after the network was temporarily disconnected, click Remount.
• If a file is added to the Amazon S3 bucket from a folder other than the TeraStation's Amazon S3 remote
replication folder, it may take up to an hour for the file to appear in the TeraStation's Amazon S3 remote
replication folder. However, when a file is added to the TeraStation's Amazon S3 remote replication folder, it
immediately appears in the bucket.
• After creating a new Amazon S3 bucket, Amazon S3 settings may not be immediately available. In such a
case, please wait up to 4 hours before attempting to configure Amazon S3. If you still cannot enable Amazon
S3 after 4 hours, check the following:
Can the TeraStation access the Internet? From Network - Ping, enter an IP address such as "8.8.8.8" (Google).
Are all Amazon S3 credentials correct?
Can you access the Amazon S3 website (http://aws.amazon.com/s3) from a browser on your computer?
76
Advertisement
Table of Contents
