Table of Contents
Advertisement
1
In Settings, click Network.
2
Click
to the right of "IP Address".
3
Click the LAN port where the jumbo frames will be used.
4
Click Edit.
5
Enter the desired Ethernet frame size and click OK.
Notes:
• To use jumbo frames, your computer's NICs and all switches, hubs, and routers on the network need to
support jumbo frames. If any device on the network does not support jumbo frames, use standard frames
(1500 bytes) instead.
• Frame sizes smaller than 1500 bytes are not supported.
• The maximum frame size depends on the LAN port: LAN ports 1–4 (10/100 ports) have a maximum frame size
of 9216 bytes while LAN ports 5 and 6 (10 Gb expansion ports) have a maximum frame size of 9000 bytes.
• Frame sizes are used as shown. Some systems subtract 18 bytes from the entered value, but the TS7000 does
not.
• If the TeraStation is being used as an iSCSI hard drive, to change the settings, navigate to Drives - iSCSI and
move the iSCSI switch to the
position temporarily before changing network settings.
137
Advertisement
Table of Contents
