Buffalo TeraStation 7000 User Manual page 152

I16 Creating RAID array x.
Resynchronizing RAID array x.
I17 Note: Transfer speeds are slower
during resynchronization.
Rebuilding RAID array x.
Note: Transfer speeds are slower
I18
during the rebuilding process.
Writing 0s to RAID array x, erasing all
I19
data.
I20 Formatting hard drive x.
I21 Checking hard drive x.
I22 Erasing the data for hard drive x.
Updating the TeraStation firmware.
I25 Note: Do not turn off the power
during the updating process.
I26 Initializing all settings.
I27 Checking USB hard drive x.
I28 Formatting USB hard drive x.
Displayed after replacing hard drive x
I32 when the RAID needs to be rebuilt in
Settings or formatting is necessary.
An error occurred in replication,
or synchronization between the
main TeraStation and the backup
I33
TeraStation failed during failover
configuration and some files were
not synchronized.
A hard drive set as a media cartridge
I35
has been installed in the drive x slot.
Media cartridge cannot be
decrypted. The media cartridge
I36
may have been encrypted by a
TeraStation other than this product.
I37 System recovery in progress.
I38 System recovery is complete.
Beginning recovery. All data in the
I40
drive 1 will be deleted.
Preparing to start the recovery
I42
process.
The TeraStation was started from the
USB recovery device, but the system
I43
cannot be recovered from this USB
recovery device.
Recovery from the USB recovery
I44 device was initiated, but drive 1 was
not detected.
I45 Recovery failed.
I46
Data migration or conversion (RAID
migration) is in progress.
I47
The main TeraStation in the failover
I49
configuration cannot be found.
I50 Failover maintenance is in progress.
I51 Initializing the failover configuration.
-
-
-
-
-
-
-
-
-
-
-
In Settings, either rebuild the RAID array or format
the hard drive.
In Settings, navigate to Backup - Replication and
choose "Resync" to execute resynchronization.
If the error is displayed again, contact Buffalo
technical support for assistance.
Connect to the slot that was set as a media
cartridge.
Connect to the TeraStation that performed
encryption to decrypt.
-
-
-
-
-
Make sure that drive 1 is present and fully inserted
in its slot.
-
Do not turn off the TeraStation power.
Make sure that the main TeraStation is on,
working, and connected to the network.
Do not turn off the TeraStation power.
Do not turn off the TeraStation power.
151