Therma-Stor Santa-Fe Classic Installer's & Owner's Manual

Therma-Stor Santa-Fe Classic Installer's & Owner's Manual

Hide thumbs Also See for Santa-Fe Classic:

Advertisement

INSTALLER'S & OWNER'S MANUAL
P/N 4029700 • Serial No.________________________ Install Date:___________
Sold by:
For small usage:
Free-standing dehumidification
n
for your home.
Includes installation, operating
n
and safety instructions, warranty
information and all ancillary
products.
Read and save these instructions.
n
420l Lien Rd., Madison, WI 53704
TOLL-FREE 1-800-533-7533
www.thermastor.com
sales@Santa-Fe-Products.com
TS-601 01/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Santa-Fe Classic and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Therma-Stor Santa-Fe Classic

  • Page 1 INSTALLER’S & OWNER’S MANUAL Free-standing dehumidification for your home. Includes installation, operating n and safety instructions, warranty information and all ancillary products. Read and save these instructions. P/N 4029700 • Serial No.________________________ Install Date:___________ Sold by: 420l Lien Rd., Madison, WI 53704 TOLL-FREE 1-800-533-7533 www.thermastor.com •...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Table of Contents Specifications 1. Specifications ................ 2 Part Number: 4029700 2. Installation................2 Blower: 275 CFM @ 0.0" WG 2.1 Location ................. 2 Power: 720 watts @ 80°F and 60% RH 2.1A In Humid Area, No Ducting......... 3 Supply Voltage: 115 volt –...
  • Page 3: A In Humid Area, No Ducting

    SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL 2.1A In humid area, no ducting. humidity. Local electrical codes must be followed when wiring The simplest installation is to place the Santa Fe Classic in the the control. humid area with no ducting. The air inlet on top and outlet on 2.2 Electrical Requirements the side must be at least 1’...
  • Page 4: Blower Switch

    SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL 3.2 Blower Switch The Santa Fe Classic uses a refrigeration system similar to an air Turning “ON" the fan switch will cause the unit’s internal blower conditioner’s to remove heat and moisture from incoming air, and to run continuously, whether the unit is dehumidifying or not.
  • Page 5: Refrigerant Charging

    SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL Evaporator coil frosted continuously, low dehumidifying 3. Unplug the unit, then disconnect the red and yellow wires capacity. from compressor terminals R & S. Using an ohmmeter, 1. Defrost thermostat loose or defective (Sec. 5.8). check continuity between the points listed below.
  • Page 6: C Replacing A Compressor - Nonburn Out

    SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL 5.7 Humidity Control 2. Remove and properly dispose of the system charge. DO NOT vent the refrigerant indoors or allow it to contact your The humidity control is an adjustable switch that closes when the eyes or skin.
  • Page 7: Wiring Diagram

    SANTA FE CLASSIC WIRING DIAGRAM 6. Wiring Diagram Figure 2: Electrical Schematic of the Santa Fe Classic Dehumidifier Santa Fe Classic Installer’s & Owner’s Manual...
  • Page 8: Service Parts List

    SANTA FE CLASSIC SERVICE PARTS LIST • To order contact your reseller or call 1-800-533-7533 ITEM PART NO. QTY. DESCRIPTION 4022254 Accumulator 4021475 Air Filter, Pleated, 2" x 16" x 20" 4021468 Air Filter, Foam Element 4026930 Blower w/ Capacitor 4028233 Capillary Tubes 4029168...
  • Page 9: Accessories List

    SANTA FE CLASSIC ACCESSORIES LIST • To order contact your reseller or call 1-800-533-7533 ITEM PART NO. DESCRIPTION 4021468 Pre-Filter 4021475 MERV 11 Filter (16"x20"x2") 4022220 Pump Kit 4022561 Muffler Kit 4021453 Duct Kit (includes 8" supply collar) 4020656 6" Inlet/Exhaust Hood 4020623 8"...
  • Page 10: Condensate Pump Installation Instructions

    SANTA FE CLASSIC CONDENSATE PUMP INSTALLATION INSTRUCTIONS STEP 1: The condensate pump kit STEP 2: Pre-drilled mounting holes are located STEP 3: Secure the condensate pump to the includes: drain hose, condensate pump, two near the bottom and on the same side of the unit with the two provided screws.
  • Page 11: Ductable Inlet Mounting Detail

    SANTA FE CLASSIC DUCTABLE INLET MOUNTING Ductable Inlet Instructions Exhaust Collar Mounting Instructions 1. Remove the Filters from the unit. 5. The six inch opening may be used as a fresh air inlet from outside. 2. Remove the ductable inlet from the box and remove the release paper from the tape on the inlet flanges.
  • Page 12: Muffler Kit Instructions

    SANTA FE CLASSIC MUFFLER KIT INSTRUCTIONS Component List On the Santa Fe Classic, the muffler (1) Silencer kit and condensate pump kit may (1) #8-18 Screw be used together, but the pump will (1) Instructions not be able to be mounted to the unit.
  • Page 13: Filter Installation Instructions

    SANTA FE CLASSIC FILTER INSTALLATION INSTRUCTIONS Instructions: To prevent damaging the foam filter, place it “grid side up” on top of the pleated filter and slide them both into the filter slot. Foam filter with plastic grid up. Pleated filter with air flow arrows pointed down.
  • Page 14: Warranty

    Warranty. Any delay or failure by Therma-Stor to exercise any warranty time period. The limited warranty does not cover any right or remedy will not constitute a waiver of Therma-Stor to costs related to changes to a Product or Component that may thereafter enforce such rights.
  • Page 15 Phone: 608-237-8400 • Fax: 608-222-1447 electronic or mechanical, for any purpose, without the express written permission Web: www.thermastor.com • Email: sales@thermastor.com of Therma-Stor LLC. © 2008 Therma-Stor LLC. All rights reserved.

Table of Contents