Table of Contents
Advertisement
INSTALLER'S & OWNER'S MANUAL
HVAC INSTALLER: PLEASE LEAVE MANUAL FOR HOMEOWNER
P/N 4021400 • Serial No.________________________ Install Date:___________
Sold by:
For small usage:
Free-standing dehumidification
n
for your home.
Includes installation, operating
n
and safety instructions, warranty
information and all ancillary
products.
Read and save these instructions.
n
420l Lien Rd., Madison, WI 53704
TOLL-FREE 1-800-533-7533
•
www.thermastor.com
sales@thermastor.com
•
•
© 2009 Therma-Stor LLC
Manual P/N TS-192 6/09
•
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Therma-Stor 4021400
Summary of Contents for Therma-Stor 4021400
- Page 1 Includes installation, operating n and safety instructions, warranty information and all ancillary products. Read and save these instructions. P/N 4021400 • Serial No.________________________ Install Date:___________ Sold by: 420l Lien Rd., Madison, WI 53704 TOLL-FREE 1-800-533-7533 www.thermastor.com sales@thermastor.com •...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Table of Contents Specifications 1. Specifications ................2 Part Number: 4021400 2. Installation................2 Blower: 275 CFM @ 0.0" WG 2.1 Location .................2 Power: 760 watts @ 80°F and 60% RH 2.1A In Humid Area, No Ducting......... 3 Supply Voltage: 115 volt –... -
Page 3: A In Humid Area, No Ducting
SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL 2.1A In humid area, no ducting. humidity. Local electrical codes must be followed when wiring The simplest installation is to place the Santa Fe Classic in the the control. humid area with no ducting. The air inlet on top and outlet on 2.2 Electrical Requirements the side must be at least 1’... -
Page 4: Blower Switch
SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL 3.2 Blower Switch The Santa Fe Classic uses a refrigeration system similar to an air Turning “ON" the fan switch will cause the unit’s internal blower conditioner’s to remove heat and moisture from incoming air, and to run continuously, whether the unit is dehumidifying or not. -
Page 5: Refrigerant Charging
SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL Evaporator coil frosted continuously, low dehumidifying 3. Unplug the unit, then disconnect the red and yellow wires capacity. from compressor terminals R & S. Using an ohmmeter, 1. Defrost thermostat loose or defective (Sec. 5.8). check continuity between the points listed below. -
Page 6: C Replacing A Compressor - Nonburn Out
SANTA FE CLASSIC INSTALLER'S AND OWNER'S MANUAL eyes or skin. 5.7 Humidity Control 3. Remove the burned out compressor. Use rubber gloves if there is any possibility of contacting the oil or sludge. The humidity control is an adjustable switch that closes when the relative humidity of the air in which it is located rises to the dial 4. -
Page 7: Wiring Diagram
SANTA FE CLASSIC WIRING DIAGRAM Figure 2: Electrical Schematic of the Santa Fe Classic Dehumidifier Santa Fe Classic Installer’s & Owner’s Manual... -
Page 8: Service Parts List
SANTA FE CLASSIC SERVICE PARTS LIST • To order contact your reseller or call 1-800-533-7533 ITEM PART NO. QTY. DESCRIPTION 4022254 Accumulator 4021475 Air Filter, Pleated, 2" x 16" x 20" 4021468 Air Filter, Foam Element 4026930 Blower w/ Capacitor 4021589 Capillary Tubes, .050"... -
Page 9: Optional Remote Humidity Control
SANTA FE CLASSIC OPTIONAL REMOTE HUMIDITY CONTROL CAUTION! This should only be performed by a qualified electrician. A 110-120 VAC remote humidity control is available from the factory. This replaces the factory mounted humidity control on the cabinet of the dehumidifier, and allows the unit to accurately sense the humidity in an area other than the one where the unit is located. -
Page 10: Condensate Pump Installation Instructions
SANTA FE CLASSIC CONDENSATE PUMP INSTALLATION INSTRUCTIONS STEP 1: The condensate pump kit STEP 2: Pre-drilled mounting holes are located STEP 3: Secure the condensate pump to the includes: drain hose, condensate pump, two near the bottom and on the same side of the unit with the two provided screws. -
Page 11: Ductable Inlet Mounting Detail
SANTA FE CLASSIC DUCTABLE INLET MOUNTING Ductable Inlet Instructions Exhaust Collar Mounting Instructions 1. Remove the Filters from the unit. 5. The six inch opening may be used as a fresh air inlet from outside. 2. Remove the ductable inlet from the box and remove the release paper from the tape on the inlet flanges. -
Page 12: Muffler Kit Instructions
SANTA FE CLASSIC MUFFLER KIT INSTRUCTIONS Component List On the Santa Fe Classic, the muffler (1) Silencer kit and condensate pump kit may (1) #8-18 Screw be used together, but the pump will (1) Instructions not be able to be mounted to the unit. -
Page 13: Filter Installation Instructions
SANTA FE CLASSIC FILTER INSTALLATION INSTRUCTIONS Instructions: To prevent damaging the foam filter, place it “grid side up” on top of the pleated filter and slide them both into the filter slot. Foam filter with plastic grid up. Pleated filter with air flow arrows pointed down. -
Page 14: Warranty
Limited Warranty Limited Warranty. Therma-Stor, LLC (“Therma-Stor”) warrants Customer Responsibilities. As a further condition to obtaining as follows: (i) the Santa Fe Classic dehumidifier (“Product”) warranty coverage hereunder, the Customer must send a valid will be free of material defects in workmanship or materials for warranty claim to Therma-Stor such that Therma-Stor receives a period of three (3) years (“Three-Year Warranty”) following such claim prior to the end of the applicable warranty period. - Page 15 Information in this document is subject to change without notice. No part of PO Box 8680 • Madison, WI 53708 this document may be reproduced or transmitted in any form or by any means, Phone: 608-222-5301 • Fax: 608-222-1447 electronic or mechanical, for any purpose, without the express written permission Web: www.thermastor.com •...
Need help?
Do you have a question about the 4021400 and is the answer not in the manual?
Questions and answers