Advertisement

P/N 4029720 • Serial No.________________________ Install Date:___________
Sold by:
For small usage:
Free-standing dehumidification
n
for your home.
Includes installation, operating
n
and safety instructions, warranty
information and all ancillary
products.
Read and save these instructions.
n
420l Lien Rd., Madison, WI 53704
TOLL-FREE 1-800-533-7533
www.thermastor.com
sales@Santa-Fe-Products.com
TS-798 7/24/14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Santa Fe Elite and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Therma-Stor Santa Fe Elite

  • Page 1 Free-standing dehumidification for your home. Includes installation, operating n and safety instructions, warranty information and all ancillary products. Read and save these instructions. P/N 4029720 • Serial No.________________________ Install Date:___________ Sold by: 420l Lien Rd., Madison, WI 53704 TOLL-FREE 1-800-533-7533 www.thermastor.com sales@Santa-Fe-Products.com •...
  • Page 2: Table Of Contents

    5.8 Defrost Thermostat ............6 2.1 Location 5.9 Condensate Pump ............6 The Santa Fe Elite is designed to be installed indoors and is 6. Wiring Diagram..............7 ideal for unfinished and finished basements. The Santa Fe Elite 7. Service Parts List ..............8 is designed to operate in temperatures between 56°...
  • Page 3: A In Humid Area, No Ducting

    See section 2.4 for attaching duct collars & ducting. If the Santa Fe Elite is located too far from a floor drain for the 2.1C In A Remote Area, Duct Inlet & Outlet. attached hose to reach, 1/2" PVC pipe can be used to extend it.
  • Page 4: Blower Switch

    4.1 Air Filter pressure and temperature to drop. It next enters the evaporator coil The Santa Fe Elite is equipped with 2 air filters. A foam pre-filter where it absorbs heat from the incoming air and evaporates followed by a standard MERV-11 65% efficient pleated fabric filter.
  • Page 5: Refrigerant Charging

    SANTA FE ELITE INSTALLER'S AND OWNER'S MANUAL 5.4 Refrigerant Charging 5. Compressor terminals C and R: No continuity indicates If the refrigerant charge is lost due to service or a leak, a new an open run winding. The compressor must be replaced.
  • Page 6: C Replacing A Compressor - Nonburn Out

    SANTA FE ELITE INSTALLER'S AND OWNER'S MANUAL 5.8 Defrost Thermostat of sludge and the suction line is also clean or perhaps has some light carbon deposits, the burn out occurred The defrost thermostat is attached to the refrigerant while the compressor was not rotating. Contaminants are suction tube between the accumulator and compressor.
  • Page 7: Wiring Diagram

    SANTA FE ELITE WIRING DIAGRAM 6. Wiring Diagram Figure 2: Electrical Schematic of the Santa Fe Elite Dehumidifier Santa Fe Elite Installer’s & Owner’s Manual...
  • Page 8: Service Parts List

    Optional Ducting Kit (for inlet & outlet; not shown) 4020623 Optional Outlet Collar (for ducting outlet only; not shown) 4022220 Condensate Pump Kit (see page 10) 4021586 Ductable Inlet Kit (see page 12) 4022561 Silencer Kit (see page 13) Santa Fe Elite Installer’s & Owner’s Manual...
  • Page 9: Accessories List

    4020623 8" Supply Collar 4020175 Remote Dehumidistat SANTA FE ELITE OPTIONAL REMOTE HUMIDITY CONTROL CAUTION! 5. Insert a romex connector or conduit connector into the hole in This should only be performed by a qualified electrician. the cabinet that is left after the dehumidistat is removed. Pass...
  • Page 10: Condensate Pump Installation Instructions

    SANTA FE ELITE CONDENSATE PUMP INSTALLATION INSTRUCTIONS STEP 1: The condensate pump kit STEP 2: Pre-drilled mounting holes are located STEP 3: Secure the condensate pump to the includes: drain hose, condensate pump, two near the bottom and on the same side of the unit with the two provided screws.
  • Page 11: Ductable Inlet Mounting Detail

    7. Place the collar over the blower outlet and line up the tabs the guides. with the holes in the cabinet. 4. Replace the filters in the unit. 8. Using (4) screws from the kit, attach the collar to the unit. Ductable Inlet Exhaust Collar Santa Fe Elite Installer’s & Owner’s Manual...
  • Page 12: Muffler Kit Instructions

    SANTA FE ELITE MUFFLER KIT INSTRUCTIONS Component List On the Santa Fe Elite, the muffler kit (1) Silencer and condensate pump kit may be (1) #8-18 Screw used together, but the pump will not (1) Instructions be able to be mounted to the unit.
  • Page 13: Filter Installation Instructions

    Foam filter with plastic grid up. Pleated filter with air flow arrows pointed down. Foam filter with plastic grid up. Pleated filter with air flow arrows pointed down. Santa Fe Elite Installer’s & Owner’s Manual Santa Fe Elite Installer’s & Owner’s Manual...
  • Page 14: Warranty

    Limited Warranty. Therma-Stor, LLC (“Therma-Stor”) warrants Customer Responsibilities. As a further condition to obtaining as follows: (i) the Santa Fe Elite dehumidifier (“Product”) will be warranty coverage hereunder, the Customer must send a valid free of material defects in workmanship or materials for a period warranty claim to Therma-Stor such that Therma-Stor receives of two (2) year (“Two-Year Warranty”) following the date of initial...
  • Page 15 Phone: 608-237-8400 • Fax: 608-222-1447 electronic or mechanical, for any purpose, without the express written permission Web: www.thermastor.com • Email: sales@thermastor.com of Therma-Stor LLC. © 2008 Therma-Stor LLC. All rights reserved.

This manual is also suitable for:

Santa fe elite 4029720

Table of Contents