Windshield Washer Fluid - Pontiac Montana SV6 2007 Owner's Manual

How to Check Power Steering Fluid
To check the power steering fluid, do the following:
1. Turn the key off and let the engine
compartment cool down.
2. Wipe the cap and the top of the reservoir
clean.
3. Unscrew the cap and wipe the dipstick with a
clean rag.
4. Replace the cap and completely tighten it.
5. Remove the cap again and look at the
fluid level on the dipstick.
The fluid level should be somewhere within the
cross-hatched area on the dipstick. If the fluid is
at the ADD mark, you should add fluid.
What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 530.
Always use the proper fluid. Failure to use the
proper fluid can cause leaks and damage hoses
and seals.
442

Windshield Washer Fluid

What Washer Fluid to Use
When you need windshield washer fluid, be sure to
read the manufacturer's instructions before use. If
you will be operating your vehicle in an area where
the temperature may fall below freezing, use a fluid
that has sufficient protection against freezing.
Adding Washer Fluid
Open the cap with the
washer symbol on it.
Add washer fluid until
the tank is full. See
Engine Compartment
Overview on page 420
for reservoir location.