Pontiac Montana SV6 2007 Owner's Manual page 19

5. To release the front seat hooks from the floor
pins, squeeze the angled bar, located beneath
the seat toward the straight crossbar.
6. Remove the seat by rocking it slightly forward,
then toward the rear of the vehicle while
pulling it out. This should be done in
one motion.
Installing the Bucket Seats
CAUTION:
{
A safety belt that is improperly routed, not
properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After installing the seat,
always check to be sure that the safety
belts are properly routed and attached, and
are not twisted.
Do not install the seat facing the rear of the
vehicle, as it will not lock into place. If more
storage room is needed behind the seat, slide
the seat forward.
Make sure the seat is in the full rear position
before beginning this procedure.
19