Pontiac Montana SV6 2007 Owner's Manual page 163

Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to time out or quit after several seconds
of transmission. This may not be long enough
for Universal Home Remote to pick up the signal
during programming. Similarly, some U.S. gate
operators are manufactured to time out in
the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator or garage door
opener by using the "Programming Universal
Home Remote" procedures, regardless of where
you live, replace Step 3 under "Programming
Universal Home Remote" with the following:
Continue to press and hold the Universal Home
Remote button while you press and release every
two seconds (cycle) the hand-held transmitter
button until the frequency signal has been
successfully accepted by the Universal Home
Remote. The Universal Home Remote indicator
light will flash slowly at first and then rapidly.
Proceed with Step 4 under "Programming
Universal Home Remote" to complete.
Using Universal Home Remote
Press and hold the appropriate Universal Home
Remote button for at least half of a second. The
indicator light will come on while the signal is being
transmitted.
Erasing Universal Home Remote
Buttons
To erase programming from the three Universal
Home Remote buttons do the following:
1. Press and hold down the two outside buttons
until the indicator light begins to flash, after
20 seconds. Do not hold the two outside
buttons for longer than 30 seconds.
2. Release both buttons.
The Universal Home Remote is now in the training
(learning) mode and can be programmed at any
time beginning with Step 2 under "Programming
Universal Home Remote" shown earlier in
this section.
Individual buttons cannot be erased, but they can
be reprogrammed. See "Reprogramming a Single
Universal Home Remote Button" following this
section.
163