Pontiac Montana SV6 2007 Owner's Manual page 121

Power Sliding Door Operation
The power sliding door(s) will only open if the
transaxle is in PARK (P). The transaxle does not
have to be in PARK (P) to close the door(s).
There are several ways to open and close the
power sliding door(s).
•
If your vehicle has a single power sliding door,
press the top of the overhead console PSD
activation/override (deactivation) switch.
•
If your vehicle has dual power sliding doors,
press the top of the driver's side and/or
passenger's side overhead console PSD
activation/override (deactivation) switch.
•
Press the passenger PSD activation switch.
This switch will also stop a moving door
immediately.
•
Press the power sliding door button on the
remote keyless entry transmitter.
•
To manually open the power sliding door(s)
while the switch(es) are in the activation
position, pull and release the inside or outside
door handle to release the door latch. The
door will fully open.
•
To manually close the power sliding door(s)
while the switches are in the activation position,
pull the inside or outside door handle or the
edge of the door. Move the door about 4 inches
(10 cm) toward the closed position and release
it. The door will close completely and latch.
If a power sliding door is locked, it cannot be
unlocked and opened using the overhead console
PSD switch(es) or the passenger PSD activation
switch(es). The power sliding door must either be
manually unlocked or unlocked using the power
door unlock switch located on the driver's or front
passenger's armrest, and then opened using the
overhead or passenger PSD activation switch(es).
The remote keyless entry transmitter can also be
used to open the power sliding door(s). If the
vehicle is locked, press the power sliding door
button(s) and all doors will unlock and the sliding
door(s) will open. See Remote Keyless Entry
System Operation on page 105.
121