Pontiac Montana SV6 2007 Owner's Manual page 29

Installing the Third Row Seat
CAUTION:
{
A safety belt that is improperly routed, not
properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After installing the seat,
always check to be sure that the safety
belts are properly routed and attached,
and are not twisted.
Do not put the third row seat in so it faces
rearward because it will not latch that way. The
seat needs to be installed before the convenience
center. See Convenience Center on page 170
for more information.
Notice: Folding a rear seat with the safety
belts still fastened may cause damage to the
seat or the safety belts. Always unbuckle
the safety belts and return them to their normal
stowed position before folding a rear seat.
For ease of installing the seat, put the seat in the
folded position before beginning this procedure.
1. From the rear of the vehicle, place the front
hooks of the seat onto the front floor pins in the
third row. To do this, the seat will need to be
angled approximately 8-10 inches (20-25 cm)
from the floor so the front hooks clear the rear
floor pins and rear floor cups. Use the release
handle to guide the seat into place.
If the front hooks are not attached correctly,
the rear latches will not attach to the rear set
of floor pins.
29