Technical Data; Transportation; Transportation In Vehicle; Starting Operation - WAGNER ProSpray 3.25 Operating Manual

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Stand:
Cart:
Low cart:
Special high-pressure hose: DN 6 mm, 15 m, connection
Dimensions (L X W X H):
Stand:
High cart:
Low cart:
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the spars, and then
push in the handle.
2
3.7

Transportation in vehicle

Secure the unit with a suitable fastening.
Uncontrolled Copy
220~240 Volt AC, 50/60 Hz
6.0 A @ 230VAC
3 x 1.5 mm 2 – 6 m
1100 Watt
221 bar (22.1 MPa)
2.6 l/min
0.027 inch – 0.69 mm
43°C
25.000 MPa·s
17.9 kg
27.4 kg
27.4 kg
thread M 16 x 1.5
436 x 369 x 416 mm
611 x 481 x 734 mm
1148 x 541 x 485 mm
80 dB (A) *
1
2
GB
4.

Starting operation

4.1 High-pressure hose, spray gun and
separating oil
1. Screw the high-pressure hose (2) to the coating material
outlet (Fig. 3, Item 1).
2. Screw the spray gun (3) with the selected tip onto the
high-pressure hose.
3. Tighten the union nuts at the high-pressure hoses firmly
so that coating material does not leak.
2
4. Remove the oil cup cap with a straight-slot screwdriver.
5. Fill the oil cup with EasyGlide (Fig. 4) until the oil gauge
(4) is showing that it is full.
EasyGlide prevents increased wear and tear to
the packings.
Attention
6. Replace oil cup cap.
7. Press oil button 2-5 times to prime the oiler. Press once
for every eight hours of usage to lubricate the fluid section.
8. Fully depress the pusher stem to make sure the inlet ball
is free.
8
Starting operation
3
1
ProSpray 3.25