What To Do If - Electrolux EVE676 User Manual

12.3 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the side lamp:
1. Remove the left shelf support to get
access to the lamp.
2. Use a narrow, blunt object (e.g. a tea-
spoon) to remove the glass cover.
Clean the glass cover.

13. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
Problem
The appliance does
not heat up.
3
4
60º
4
The appliance is deactiva-
ted.
Inserting the door
1. Hold the door on both sides at an an-
5
gle of approximately 60° (from the
side of the door with the handle).
2.
Push the door hinges at the same
time into the two recesses at the bot-
tom of the appliance on the left and
the right as far as they go.
3. Shut the door only to a point of resist-
ance and then open it as far as it
goes.
4. Lock the clamping levers on the hing-
es fully.
5. Close the door.
3.
Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat resistant oven
lamp.
4. Install the glass cover.
5. Install the shelf support.
Possible cause
ENGLISH
Remedy
Activate the appliance.
27