Electrical Connection And Other Rear Panel Elements Of Ndr-Ba4208 Dvr - Novus NDR-BA2208-II User Manual

NDR-BA2208-II, NDR-BB2208,NDR-BA2416, NDR-BA4104-II, NDR-BB4104, NDR-BA4208

2.6. Electrical connection and other rear panel elements of NDR-BA4208 DVR.

12 11 10
1. VIDEO IN:
2. VIDEO OUT:
3 LAN:
4. SPOT OUT:
5. USB:
6.AUDIO OUT:
7. VGA:
8. HDMI MONITOR: Main monitor connectors, use the HDMI cable to connect to a 1080p 60Hz
9. AUDIO IN:
10. I/O Terminal block: Input, output and RS-485 port .




11.DC12V:
12.POWER SWITCH: DVR power switch.
13.FAN:
Note:
OSD menu will be displayed on the VGA monitor by default. To switch the OSD display from VGA to
HDMI or BNC, please press and hold the ESC button for 5sec.
and NDR-BA4416
User's manual (short) ver.1.3
8 7 5
6 4
9
4
8 video inputs for connecting video signal sources to the DVR.
Main monitor connectors,
RJ-45 connector port for connecting to the local network and internet.
SPOT monitor output, allowing to display any camera/sequence of cameras
full screen.
USB 2.0 port for external Flash memory and mouse connection.
Audio out port for connecting local speaker with pre-amplifier.
Main monitor connector, VGA type. Please use signal cable provided with
the monitor when using aforementioned connection type.
(1920x1080) monitor.
Audio (mono) inputs for connecting microphones with pre-amplifiers
RS-485: two RS-485 bus ports for connecting external keyboard (K/D:
A+, B-) and PTZ cameras (P/Z: Y+, Z-)
ALARM IN: 16 alarm inputs, which may be set either as normally open
(N.O.) or normally closed (N.C.). In order to detect the alarm, signal
should last for minimum 0.5sec .
ALARM OUT(NO, COM): Alarm relay output, max. load capacity of
the outputs is 0,5A/125VAC and 1A/30VDC.
GND: Grounding
12V DC power socket for connecting included power adaptor.
Cooling fan, do not cover!
All rights reserved © AAT Holding sp. z o.o.
16
STARTING THE DEVICE
3
3
2
1
2
1
13