Installing 5.25-Inch And 3.5-Inch Drives - Micron Millennia Series Technical Reference Manual

5
6
I ns talli ng 5. 25 -in ch and 3. 5 -in ch D ri ves
1
2
3
Disconnect any power, data, or audio cables that may be connected to the drive. You may need
to slide the drive partially out of the bay to accomplish this.
Remove the drive as shown in Figure 17.
Figure 17. Removing the Device
To install or replace a drive, follow these instructions:
Remove the plastic bay cover and the metal bay cover if they are in place. There will only be a
drive bay cover if you are installing a drive into a previously empty drive bay.
Slide the drive into the bay.
Connect power, data, and audio cables as necessary.
I N S T A L L I N G A N D R E M O V I N G H A R D W A R E
Installing and Removing Drives
6-45