Removing The Bezel - Micron Millennia Series Technical Reference Manual

R E M O V I N G T H E B E Z E L
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
You will need to remove the bezel in order to remove, install, or replace any of the drives.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Note
The micro-tower case has two bezel options. See "System Features" in the Getting Started Guide for a
description of both bezels. Removing and replacing the bezel is the same for both bezel options.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To remove the bezel:
1 Place the front of the system over the edge of a table about 1-inch or tilt it up enough to grab the
handle. If the bezel is secure and does not come away easily, it may be necessary to set the
computer on its back as shown in Figure 8.
2 Grip the handle located at the bottom of the bezel.
Figure 8. Bezel Handle
TA K I N G A P A R T YO U R S Y S T E M
Bezel
Handle

Removing the Bezel

5-33