Jumper Settings - Micron Millennia Series Technical Reference Manual

S Y S T E M B O A R D
7
System Board Components
Jumpe r Se tti ngs
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warning
System power must be off when moving these jumpers.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table 6:

Jumper Settings

Jumpers Settings
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
JP13-CLEAR Default: Pins 1 and 2 are covered. To clear the CMOS, use the following procedure:
Password/CMOS 1.
2.
3.
4.
5.
6.
7-58
Turn off the computer.
Move the JP13 jumper from the 1-2 position to the 2-3 position.
Wait at least 30 seconds for the CMOS to clear, then return the JP13 jumper to the 1-2 position.
Turn on the system and press [Delete] to enter the BIOS setup.
Select the Defaults menu and select Load default settings.
Press [F10] to save settings and exit setup.