Replacing The Access Panels - Micron Millennia Series Technical Reference Manual

TA K I N G A P A R T YO U R S Y S T E M
5

Replacing the Access Panels

2 Slide Access Panel 2 back about 1-inch as shown in Figure 5, page 5-30.
3 Lift Access Panel 2 as shown in Figure 6, page 5-30.
R E P L A C I N G T H E A C C E S S P A N E L S . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To replace the access panels:
1 Begin with the computer laying on its side.
2 Place the access panel on the computer and line up the hooks on the cover with the
corresponding slots in the chassis. This should place the cover approximately 1/2-inch back.
3 Slide the access panel toward the front of the unit until it is set in place.
4 Replace the two thumbscrews that secure Access Panel 1 in place as shown in Figure 4,
page 5-29.
5 Replace the screws that secure Access Panel 2 in place as shown in Figure 7, page 5-31.
5-32