Monitor Measurement - GMB Spectrolino Operation Manual

Spectrolino
3
operation
16
EN
Position the instrument on the calibration plate (19) with the white reference (17),
so that light can not enter the measuring aperture. Emissive calibration can only
be initiated via software activation.

3.4.2.2 Monitor measurement

The Spectrolino is equipped with a monitor support (25) for emissive measurement.
To set up for this measurement, insert the support's folding tab (24) into the slot (16)
on the instrument until it locks in position. Attach the measuring device to the monitor
support (25) by means of the sliding lock (23).
Position the Spectrolino on the monitor. The suction cups (27) are
operated by pressing the pressure buttons (26). Usually, mea-
surement is started by software. A succession of three brief tones
confirms successful measurement.
- The Spectrolino may be removed from the monitor by pulling the vent
tabs (28) of the suction cups (27). To avoid damage to the device, never
pull the pressure buttons (26) to release the instrument.