Installing A 2.5-Inch Drive Into A 3.5-Inch-Drive Bay - Lenovo ThinkServer RD650 User Manual And Hardware Maintenance Manual

8. Align the holes in the drive tray with the corresponding ones on the new easy-swap drive. Then, install
the four screws to secure the drive to the drive tray.
Figure 130. Installing the drive to the drive tray
9. Slide the new easy-swap drive into the drive bay from the front until it snaps into position, and then
close the handle.
Figure 131. Installing the easy-swap drive
10. Do one of the following:
• If you are installing a drive, save the removed dummy tray in case that you later remove the drive
and need a dummy tray to cover the drive bay.
• If you are replacing a drive and are instructed to return the old drive, follow all packaging instructions
and use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To configure RAID, go to "Configuring RAID" on page 62.

Installing a 2.5-inch drive into a 3.5-inch-drive bay

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 67.
.
Chapter 6 Replacing hardware
147