Zoom Brush Position Check/Adjustment And Pattern Check - Sony SAL1870 Service Manual

4-6.

ZOOM BRUSH POSITION CHECK/ADJUSTMENT AND PATTERN CHECK

Note:
If dialog box of error code appears during the checking or adjustment, check the reason of error referring to page 4-23.
4-6-1. Zoom Brush Position Check
Equipment
• Personal Computer (PC)
• Camera DSLR-A100
• USB Cord With Connector
• Lens Adjustment Program
Note:
Lens Adjustment Program is downloadable from the ESI homepage.
1. Preparations
1) Connect the checking lens to the camera.
2) Start the lens adjustment program "LensAdjustment.exe" referring to "4-1-2. Lens Adjustment Program".
2. Checking Method
[Connect]
1) Click the
Note:
Click the
[Zoom]
2) Click the
3) Set the zoom position to Tele end, and check that the OK (Green) indicator of "Position" lights as shown in Fig. 4-6-3.
Note:
Lens focus position setting is not required.
If the NG (Red) indicator of "Position" lights, perform the "4-6-2. Zoom Brush Position Adjustment and Pattern Check".
[Exit]
4) Click the
[End]
5) Click the
6) Turn the POWER switch of the camera to OFF.
SAL1870 (3.5-5.6/18-70) (DT 18-70mm F3.5-5.6)
Fig. 4-6-1
button on the lens adjustment program.
[End]
button to disconnect the USB connection, then lens adjustment program will terminate.
Fig. 4-6-2
button on the lens adjustment program.
Fig. 4-6-3
Fig. 4-6-4
button.
button to terminate the lens adjustment program.
4-17