Cabinet Installation - Superior VRT4032ZEN Installation And Operation Instruction Manual

10. Carefully insert fireplace into cabinet mantel.
Be careful not to scratch or damage hearth
base, cabinet mantel, or any laminate trim
on hearth base. Remove protective material
from top of hearth base and from front of
fireplace (if any).
Note: You can secure fireplace to hearth
or floor. Remove burner assembly. Locate
screw holes in bottom of base. Tighten
wood screws through these holes and into
hearth or floor. Replace burner assembly.
11. Check all gas connections for leaks. See
Checking Gas Connections, page 15.
Figure 10 - Installing Cabinet Mantel
Figure 11 - Location of Nailing Flange
126867-01A
INSTALLATION
Continued
Cabinet
Mantel
Nailing
Flange
www.SuperiorFireplaces.US.com
Figure 12 - Inserting Fireplace Into
Cabinet Mantel
BUILT-IN FIREPLACE
INSTALLATION
Built-in installation of this fireplace involves
installing fireplace into a framed-in enclosure.
This makes the front of fireplace flush with wall.
If installing a mantel above the fireplace, you
must follow the clearances shown in Figure
16, page 12. Follow the instructions below to
install the fireplace in this manner.
Rough Opening Dimensions for Built-in
Installation
Front Width
Model
(Inside to Inside)
32" 34
36" 41
1. Frame in rough opening. Use dimensions
shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 14,page 12, Figure 13,
for the rough opening.
Height
(Inside to Inside)
Figure 13 - Rough Opening for Installing
Height Depth
/ " 36 / " 16
7 3
8 4
/ " 40 / " 20
1 1
2 2
Depth
(Minimum)
Width
in Wall
/ "
1
4
/ "
3
4
11