Superior VRT4032ZEN Installation And Operation Instruction Manual page 28

TOUCH PAD OPERATION
This touch control has only 3 buttons for con-
trolling manually the flame of the appliance
(see Figure 44).
The touch pad has:
1. Led display
2. ON/OFF button
3. UP button
4. DOWN button
With this control it is possible to turn on the
fire, turn off the fire and control the flame level.
LED Display
ON/OFF Button
UP Button
DOWN Button
Figure 44 - Touch Pad Control
Note: The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. Unplug, turn
over, and reconnect.
SWITCHING ON
To turn the system on just press the ON/OFF
button. The system will emit a beep and begin
the ignition process, which can take about
20 seconds. Once the start up process is
complete, the pilot flame is lit.
REGULATING THE FLAME LEVEL.
1. To increase the flame level, press the
up button (
the LED indicate that the system has
accepted the order, and the flame will
increase instantly (see Figure 44).
2. To decrease the flame level, press the
down button (
the LED indicate that the system has
accepted the order, and the flame will
decrease instantly (see Figure 44).
28
OPERATION
ON
OFF
). A beep and a flash of
). A beep and a flash of
www.SuperiorFireplaces.US.com
Continued
SWITCHING OFF
To switch off the fire, the ON/OFF button
should be pressed. After the system has emit-
ted a beep, the fire switches off.
WARNING: Do not convert
heater to use different fuel type.
Only use heater with fuel type
specified.
Thermocouple
Figure 45 - Pilot (Natural)
WARNING: This fireplace has
a three-prong, grounded electri-
cal plug. This plug helps protect
you against electrical shock.
Only connect plug to a properly
grounded, three-prong recep-
tacle. Do not cut or remove the
grounding prong from this plug.
Access the blower control knob by pushing in
on the bottom corners of the fireplace screen,
grasp the bottom of the screen and pull out
and up to remove the screen. The blower
control knob is located on the left side of the
fireplace floor.
The blower is thermostatically controlled. This
means the fireplace and blower will not turn
on and off at the same time. The fireplace
may run for several minutes before the blower
turns on. After the fireplace is shut off, the
blower will continue to operate until the fire-
place temperature cools.
The blower also includes a variable speed
control. Turn the knob clockwise to turn the
blower to the high position. Continuing to turn
the knob will reduce the speed of the blower
until it reaches a preset low speed.
Ignitor Electrode
Pilot Burner
BLOWER
OPERATION
126867-01A