Superior VRT4032ZEN Installation And Operation Instruction Manual page 17

TOUCH PAD INSTALLATION
Locate the touch pad wire harness and the
touch pad control (see Figure 25). They are
shipped from the factory in the clear plastic
bag with your owner's manual. Connect the
black plastic connectors together as shown
in Figure 26. Connect the remaining end
with the white plastic connector to the control
module in the socket marked TOUCH LED
(see Figure 27).
NOTE: The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. You must
unplug the touch pad control from the touch
pad wire harness, turn over, and reconnect.
Touch Pad Control
Figure 25 - Touch Pad Wire Harness and
Touch Pad Control
Figure 26 - Touch Pad Control Cable
Figure 27 - Connecting end of Touch Pad
126867-01A
INSTALLATION
Touch Pad Wire
Harness
Cable
www.SuperiorFireplaces.US.com
Continued
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove
the data plates attached to the
heater base assembly. The data
plates contain important safety
and warranty information.
1. Place fiber ramp log in center of chassis
as shown in Figure 28. The fiber ramp log
can be identified by the shape and much
lighter weight when compared to the other
logs. The log must sit flat on the black
sheet metal and behind the left metal tab
as shown. Make sure the side marked
''BOTTOM'' is setting down.
2. Place front left and front right logs as shown
in Figure 29.
Ramp Log
Metal
Tab
Figure 28 - Installing Fiber Ramp Log
Right Front Log
Left Front
Log
Figure 29 - Installing Left/Right Front Logs
17