ON) to indicate the change has been
made.
Flame-A (or Main) Adjustment
•
Transmits a flame height setting com-
mand to the control module to adjust the
Flame-A height.
•
Available settings are 1-3 with a factory
default of 3. Refer to the THERMOSTAT
Mode section for additional details on
flame modulation in THERMOSTAT
mode.
•
While in MANUAL ON, THERMOSTAT
ON, or PROGRAM ON modes, touch
the FLAME Zone to enter Flame-A Ad-
justment, then press the UP or DOWN
buttons to raise and lower the flame;
press the MODE/SET Button or wait for
15 seconds to accept the new setting.
•
LCD Display: When setting the Flame-A
height, the Flame-A icon, and Flame-A
setting number will flash in the FLAME
Zone.
Child-Lock Operation
•
Child-Lock operation prevents any user
input to the transmitter. No mode of op-
eration or feature may be adjusted when
Child-Lock is activated. All automatic
functions (thermostat, program, etc.) will
continue normally.
•
To activate or deactivate the Child-Lock
feature, press and hold the MODE/SET
and DOWN Buttons simultaneously for
5 seconds.
•
LCD Displays:
• When activated, the LOCK icon will ap-
pear in the MODE Zone.
• If any touch-zone or button is pressed
when activated, the LCD backlight will
illuminate and the LOCK icon will flash
for 5 seconds in the MODE Zone.
Room Temperature Limit
•
The Room Temperature Limit Shut-
down feature will operate in MANUAL
ON, THERMOSTAT ON mode, and
PROGRAM ON modes. If the room tem-
perature reaches 95 deg. F or greater,
the transmitter will automatically change
to MANUAL OFF mode and send a
MANUAL OFF command to the control
module. If the user turns the control
back ON and the room temperature is
126867-01A
OPERATION
Continued
www.SuperiorFireplaces.US.com
still 95F or greater, the transmitter will
switch to back manual OFF and send
another OFF command the next time
the transmitter reads & updates the room
temperature (2-minute update interval).
PAIRING
The remote and receiver are paired at the
factory but in case they do not communicate
after proving the batteries are fresh, repair-
ing may be necessary. Follow the steps
below to repair the remote to the receiver.
It is helpful to have a flashlight so you can
see the connections as described below.
Before proceeding, locate the S1 but-
ton on the receiver shown in the figure
below. You will need to access this button
during the re-pairing procedure and only
have 20 seconds to press and release it.
To enter pairing mode press and hold the
MODE/SET Button for 10-seconds.
•
Transmitter will transmit a pairing sig-
nal for 20-seconds, then automatically
exit pairing mode and return to normal
operation.
•
LCD Displays – When pairing mode is
activated:
1. MODE Zone: Blank
2. ROOM TEMP Zone: The letters "On"
will flash.
3. SET TEMP Zone: The letter "P" is
displayed
4. TIME/PROG Zone: Blank
5. FLAME Zone: Blank
Receiver Operation Note: Once transmitter
is in pairing mode, press the yellow or black
pairing button on the receiver.
Connect Battery Plug Here
Control Module
S1 Button
27