System Specification; Component Main Data - Kontron 886LCD-M/ATX User Manual

KTD-00474-U

3. System specification

3.1 Component main data

The table below summarises the features of the 886LCD-M/Flex, 886LCD-M/ATX and 886LCD-M/mITX
embedded motherboards.
886LCD-M/Flex: Flex-ATX (190,50mm by 228,60mm)
Form factor
886LCD-M/ATX: ATX (190,50mm by 304,00mm)
886LCD-M/mITX: mini ITX (170.18mm by 170.18mm)
•
Support for Intel Pentium M and Celeron M Processors in mPGA478 socket with
Processor
400MHz system bus.
•
Banias (0.13um) and Dothan (0.09um) family processors.
•
/Flex and /ATX: 2x184pin DDR SDRAM Dual Inline Memory Module (DIMM) sockets.
Memory
•
/mITX: 1x184pin DDR SDRAM Dual Inline Memory Module (DIMM) socket.
•
Support for DDR 266/333 (PC2100/PC2700)
•
Support for 128MB up to 2GB of system memory (/Flex and /ATX)
•
Support for 128MB up to 1GB of system memory (/mITX)
•
ECC not supported
Intel 855GME Chipset consisting of:
Chipset
•
Intel® 855GME Chipset Graphics and Memory Controller Hub (GMCH)
•
Intel® 6300ESB I/O Controller Hub (ICH)
•
4 Mbit Firmware Hub (FWH)
•
Intel Extreme Graphics 2 controller
Video
•
Shared Video Memory up to 32MB/64MB when using min. 128MB/256MB SDRAM.
•
Analog Display Support, 350-MHz integrated 24-bit RAMDAC with support for
analogue monitors up to 2048x1536 at 75 Hz
•
Digital Video Out Port (DVOB & DVOC) support, dot clock up to 165-MHz
•
Single or dual channel LVDS panel support (18/ 24bit OpenLDI / SPWG) up to UXGA
panel resolution
•
Dual independent pipe support, Mirror and Dual independent display support
Tri-view support through LVDS interface, DVO B/C port, and CRT
•
AGP 2.0, 1.5V connector (DVO B/C muxed w/ AGP) supporting 1x, 2x, and 4x AGP
cards or an AGP Digital Display (ADD) card
Audio, AC97 version 2.3 subsystem using the Realtek ALC655 codec
Audio
•
Audio Amplifier
•
Line-out
•
CDROM in
•
SPDIF Interface (Surround)
•
Microphone
Onboard speaker
Winbond W83627THF LPC Bus I/O Controller
I/O Control
•
Four USB 2.0 ports
Peripheral
•
Four Serial ports (RS232). Note: Intel 6300ESB Serial port FIFO (COM C+D) is not
interfaces
standard compliant. May cause issues with specific SW.
•
One Parallel port, SPP/EPP/ECP / Floppy (optional floppy with special cabling)
•
Two Serial ATA 150 IDE interfaces, ATA Mode 6 not supported due to Intel Chipset
restrictions.
•
Two Parallel ATA IDE interfaces with UDMA 33, ATA-66/100 support
•
PS/2 keyboard and mouse ports
886LCD-M Family
Public User Manual
DVI DVO ADD and CRT DVO ADD supported.
LVDS DVO ADD cards currently not supported
CRT – LVDS supported
CRT - DVO/ Add card supported
LVDS - DVO/ Add card supported
/FLEX and /ATX: 4x3W
o
/mITX: 2x3W
o
Date: 2010-06-22 Page 10 of 81
(continues)