Setup Tasks Check List - IBM RT User's Setup Manual

Setup Tasks Check List
The setup tasks are as follows:
1.
Locate all the devices you will connect to the system unit.
These are the devices for one entire system setup, such as the
display, keyboard, mouse, system unit, modem, terminals,
printers, and so On.
This book refers to each device by the name printed on the
packing carton on the device logo.
2. Unpack and set up the printers, plotters, terminals, and
modems, following the instructions on the packing cartons or
the instructions shipped with each device. If the instructions
ask you to test the dev ices, do so now.
Leave enough space behind the devices so that you can
connect them to the system unit as instructed to do so in
task 6.
3. Unpack the system unit. For the IBM 6150, follow the
graphics on the packing carton. Unpack the unit near the
location in which you plan to use it. Leave enough space
behind the unit to connect the other devices to it.
Note: This book assumes the options are installed. If this
is not true, have them installed before you continue with the
setup. Follow the instructions in IBM RT PC Options
Installation, included in this binder, to install the options.
CONTINUE TO THE NEXT PAGE
Section 1. Setup Tasks Check List 1-5