Shutter Speed - GE CyberDome II User Manual

20 CyberDome II
User Manual

Shutter speed

Use this feature to select the shutter speed (Figure 26). Select the number that corresponds with the desired
speed to set the shutter speed for either a NTSC or PAL.
Figure 26. Shutter speed
During pan/tilt operation, shutter speed is controlled automatically by the camera. Set Exposure control to
automatic and enable Autoslow shutter so that shutter speed can be adjusted to enhance the video image while
the camera is in a stationary position in low or bright light. To use the settings in the Shutter speed menu during
live video, press the iris + button. Press iris - or move the camera to return the settings to automatic.
Note: When you set the shutter speed to anything other than automatic, the setting will override the manual return to autoiris
control, making the iris always fully automatic.
Site number display
Enable or disable the display of the camera site number in the upper left-hand corner of the monitor screen
(Figure 27 on page 21).
Note: Diagnostic mode will display raw pan, tilt, zoom, and protocol selected information on your live video screen. This
information is intended for use when contacting technical support.
• Select option 1 to disable site number display.
• Select option 2 to enable site number display.
• Select option 3 to enter diagnostic mode.