Table of Contents
Advertisement
Max tilt/pan speed
Use this to set the maximum pan and tilt speed (Figure 21).
Figure 21. Pan/tilt speed
To set the pan and tilt speed, do the following:
1. Select the setting you want to change.
2. Press the iris+.
3. Use the joystick to set the speed from 20 to 120 (default is 120).
4. When finished, press iris +.
Note:
The units of measure used for this feature are in degrees per second.
Pressure warning
Use this feature to enable or disable the pressure warning (Figure 22).
Note:
This menu is only enabled when using a CyberDome II camera inside a CyberDome II PressurDome housing.
Figure 22. Pressure warning
If you enable the pressure warning, you will be asked to set the level at which the warning displays. Move the
joystick up or down to choose from 0.5 PSI to 5.0 PSI in 0.1 PSI increments. The pressure warning displays on
Chapter 1
17
Programming
Advertisement
Table of Contents
Troubleshooting
