Lincoln Electric PRO-CUT 60 SVM104-A Service Manual page 76

F-35
(LATER CODES MAY HAVE TOGGLE SWITCH)
FIGURE F.13-ON/OFF Power Switch Removal/Replacement
REMOVAL/REPLACEMENT
PROCEDURE
1. Disconnect input power to the
machine.
2. Perform
DISCHARGE PROCEDURE.
3. Remove the Right Case Side
Assembly by removing the sheet
metal screws.
4. Remove the black ON/OFF
Power Switch knob and plastic
insert by unscrewing the small
screw in the center of the knob.
Remove from the shaft. See
Figure F.13.
5. Remove the face plate by
squeezing the two tabs together
and sliding the plate off.
Figure F.13.
PRO-CUT 60
TROUBLESHOOTING & REPAIR
ON/OFF POWER SWITCH REMOVAL
0
1
ON/OFF POWER SWITCH KNOB
SCREW (SECURING KNOB)
FACE PLATE
SCREWS (SECURING FACE PLATE)
SWITCH
L1 & L2 LEADS
T1 & T2 LEADS
the CAPACITOR
6. Loosen the four screws on the
plastic frame. These screws go
through
Assembly
switch. When the screws no
longer engage the line switch,
remove the line switch so it can
be worked on.
7. Remove and save the electrical
tape. The electrical tape will be
re-applied during assembly.
8. Remove leads T1, T2, L1, & L2.
9. Install new
Switch in reverse order of
removal.
electrical tape to switch.
See
the Case Front
into the line
ON/OFF Power
Be sure to re-apply