Headrests - Removing And Installing; Memory Function Of The Electrically Adjustable Seat - Skoda Octavia Operating Instructions Manual

Note
The middle rear head restraint is only adjustable in two positions.
■
For the sports seats, the head restraints are integrated into the front seat
■
backrests. This headrest can not be adjusted in height.

Headrests - removing and installing

Fig. 73 Rear headrest: Removal / Installation

Read and observe on page 81 first.
Only the real head restraints may be removed or installed.
Removing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
A
the same time using a flat screwdriver with a max. width of 5 mm to press
the securing button in opening
›
Remove the restraint in the direction of arrow
Fitting
›
Push the support in the headrest in the direction of arrow
ing button clicks into place.
WARNING
The following information must be observed
seated position.
CAUTION
Store the head restraints that were removed in such a way that they cannot
be damaged or soiled.
» Fig. 73
1
in the direction of arrow .
B 2
.
3
until the lock-
4
» page 8, Correct and safe
Note
For the sports seats, the head restraints are integrated into the front seat
backrests. These headrests can not be removed.

Memory Function of the electrically adjustable seat


Read and observe
The pre-set buttons on the driver's seat make it possible to save the driver's
seat and exterior mirror positions.
Each of the three memory buttons
Storing driver's seat and exterior mirror settings for driving forward
›
Switch on the ignition.
›
Adjust the seat and the two mirrors to the desired position.
›
, while at
Press the  button (Position
›
Within 10 seconds after pressing the  button, press the desired memory
button .
B
An acknowledgement sound confirms the storage.
Saving front passenger mirror settings for reversing
The function of lowering the passenger mirror surface when reversing must be
enabled in Infotainment
Vehicle Settings .
›
Switch on the ignition.
›
Press the required memory button
›
Turn the knob for the external mirror control to the position for the passen-
ger side mirror adjustment
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear.
Fig. 74
Memory buttons and SET button
on page 81 first.
» Fig. 74 can be assigned a set position.
B
» Fig. 74).
A
» Operating instructions Infotainment, chapter CAR -
» Fig. 74.
B
» page 79.
Seats and head restraints

83