Using the net partition
Fig. 122 Open part of the roll-up luggage compartment cover / release
lever
Fig. 123 Net partition behind the front seats in the pulled-out state
Removing the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover
the arrow
» Fig.
122.
›
Pull out the net partition at the upper crossbar
» Fig.
123.
›
Hook the crossbar into one of the receptacles
›
On the other side, press on the crossbar and hook it into the appropriate re-
ceptacle
.
E
108
Using the system
in the direction of
A
from the housing
C
D
.
E
If the crossbar is hooked into the receptacle
press on the crossbar in the direction of the arrow
ceptacle
to the right.
E
›
Make sure that the crossbar is firmly seated in the fittings
›
Fold back part of the roll-up luggage compartment cover
direction of the arrow
» Fig.
122.
Using the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover
the arrow
» Fig.
122.
›
Press on the crossbar and remove it from the receptacles
side, then on the other side
» Fig.
›
Hold the crossbar
in such a way that the net partition can slowly roll up
C
into the housing
without being damaged.
D
›
Fold back part of the roll-up luggage compartment cover
direction of the arrow
» Fig.
122.
CAUTION
If the net partition blocks when pulling it out of the housing, push the release
lever
in the direction of the arrow
B
Removing and refitting the net partition housing
Removing
›
Fold the rear seats forward
» page
›
Open the rear right door
» page
›
Push the net partition housing
move it from the mounts on the right seat backrests in the direction of the
arrow
» Fig.
124.
2
to the left for example, then
E
and insert into the re-
1
.
E
in the opposite
A
in the direction of
A
, first on one
E
123.
in the opposite
A
» Fig.
122.
Fig. 124
Removing the net partition
housing
87.
56.
in the direction of the arrow
A
1
and re-