Skoda Octavia Operating Instructions Manual page 54

Note
The ŠKODA applications, support communications devices with the Android
■
operating system version 4.x.x and later and iOS 7.x.x and higher.
With SmartGate, a device can be connected to two ongoing ŠKODA applica-
■
tions, possibly two devices, each with a respective current ŠKODA application.
If you have forgotten your password for the connection to SmartGate, Smart-
■
Gate must be reset to factory settings in a specialised workshop.
Connection to SmartGate using Wi-Fi

Read and observe and
For a successful connection the following conditions must be met.
Wi-Fi is turned on in the device to be connected.

The ignition is switched on.

Connection set-up
›
Enable the connected device to search for available Wi-Fi networks (see op-
erating instructions for the connected device).
›
In the menu of the detected networks select "SmartGate_..."
SmartGate_..." .
1)
›
Enter the password (the password is pre-set as the complete Vehicle Identi-
fication Number at the factory - enter in capital letters).
Disconnection
The connection can be switched off in one of the following ways.
›
By disconnecting the connected device from SmartGate.
›
By turning off the Wi-Fi in the connected device.
›
By switching off the ignition for more than 5 s (for vehicles with starter but-
ton by turning off the engine and opening the driver's door).
Automatic connection
If the communication device once had a connection with SmartGate, then the
connection is automatically restored under the following conditions.
Wi-Fi is turned on in the device to be connected.

The ignition is switched on.

The device to be connected has saved the password required for the con-

nection check.
1)
The last six symbols of the VIN vehicle identification number of your vehicle are displayed at position ....
on page 50 first.
or "DIRECT
1)
Connection using Wi-Fi direct to SmartGate

Read and observe and
This type of connection is provided for communication devices and applica-
tions that support connection via Wi-Fi Direct.
Connection set-up
›
Switch on the ignition.
›
In the device to be connected start the ŠKODA application that supports con-
nection via Wi-Fi Direct.
›
In the application, select the connection function (e.g. "Connect"), this starts
to search for available devices that support Wi-Fi Direct.
›
In the menu of the detected networks select from the menu "SmartGate_..."
›
Enter the PIN code (the factory default setting for the password is the last
six digits of the vehicle identification number).
If you want to connect to SmartGate from another vehicle, then after the start
of the application, disconnect the previous connection by selecting the separa-
tion function (e.g. "Disconnect ").
Disconnection
The connection can be switched off in one of the following ways.
›
In the application, the separation function (e.g. "Disconnect") is selected.
›
By turning off the Wi-Fi Direct in the connected device.
›
By switching off the ignition for more than 5 s (for vehicles with starter but-
ton by turning off the engine and opening the driver's door).
Automatic connection
If the communication device once had a connection with SmartGate, then the
connection is automatically restored after the start of the application.
SmartGate web interface

Read and observe and
In the SmartGate Web interface it is possible to set-up SmartGate and the Wi-
Fi connection to SmartGate.
The following address must be entered via Wi Fi in the web browser of the
connected device.
on page 50 first.
on page 50 first.
Information system
.
1)

51