CAUTION
Screw the jack back into the starting position before storing in the box with
■
the vehicle tool kit.
Ensure that the vehicle tool kit is safely secured in the luggage compart-
■
ment.
Ensure that the box is always secured with the strap.
■
Note
The declaration of conformity is included with the jack or the log folder.
Changing a wheel
Introduction
This chapter contains information on the following subjects:
Preparation
Remove the wheel / stow
Full wheel trim
Wheel bolts
Anti-theft wheel bolts
Loosening/tightening wheel bolts
Raising the vehicle
Remove the wheel / fix
Follow-up tasks
For your own safety and the safety of your passengers, the following instruc-
tions must be observed before carrying out a wheel change on the road.
Switch on the hazard warning light.
The warning triangle must be set up at the prescribed distance - observe
the national legal provisions when doing so.
Park the vehicle as far away as possible from the flow of traffic.
Choose a location with a flat, solid surface.
Have all the occupants get out of the vehicle. While changing a tyre, the
occupants of the vehicle should not stand on the road (they should in-
stead remain behind a crash barrier).
The national legal requirements must be observed when changing a wheel.
Preparation
Before changing the wheel, the following work must be carried out.
›
Switch off the engine.
›
For vehicles with Manual transmission select the first Gear selection.
›
On vehicles with automatic transmission, place the selector lever in the P
position.
›
The parking brake switch.
›
Uncouple any trailers.
Remove the wheel / stow
209
209
210
210
210
211
211
The wheel is located in a well under the floor covering in the boot and is fixed
in place with special bolt
212
212
Take out the wheel
›
Open the boot lid.
›
Raise the floor covering in the boot
›
Loosen the retaining belt and take out the box with the tool kit.
›
Remove locking
in the direction of arrow
A
›
Unscrew nut
in the direction of arrow
B
›
Remove the wheel.
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
›
Pull the fixing band through the opposite holes in the wheel rim.
›
Screw in nut
in the opposite direction to arrow
B
›
Insert locking
in the opposite direction to which arrow
A
›
Replace the box with the tool kit into the emergency or spare wheel and se-
cure it with the tape.
›
Fold back the floor covering in the boot
›
Shut the boot lid.
Fig. 210
Take out the wheel
» Fig.
210.
B
» page
101.
» Fig.
210.
1
.
2
» Fig.
2
» page
106.
Emergency equipment, and self-help
210.
is pointing.
1
209