Daylight Running Lights (Day Light) - Skoda Octavia Operating Instructions Manual

All seats occupied, boot loaded

Driver seat occupied, boot loaded

Xenon headlight
The Xenon bulbs adapt automatically to the load and driving state of the vehi-
cle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Xenon headlights do not have a manual headlight range adjustment
control.
WARNING
Always set the headlight range control so that other road users are not
dazzled, in particular oncoming vehicles.
Note
The light switch is in position  or  and the ignition is turned off, the low
■
beam is switched off automatically
switched off when the ignition key is removed, for vehicles with the KESSY
system after switching off the ignition and opening the driver's door.
If there is a fault in the light switch, the low beam comes on automatically.
■

Daylight running lights (DAY LIGHT)


Read and observe on page 67 first.
The daytime running lights (the only function) provides the lighting of the front
vehicle range.
The lights are switched on automatically if the following conditions are met.
The light switch is in the position  or .

The ignition is switched on.

The function is activated.

Activating/deactivating function on vehicles with Infotainment
The function can be disabled/enabled in the Infotainment
tions Infotainment, chapter CAR - vehicle settings.
Deactivating on vehicles without Infotainment
›
Switch off the ignition.
1) Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page 72.
68
Using the system
and the status light is lit. The side light is
1)
» Operating instruc-
›
Pull the indicator / main beam lever towards the steering wheel, push down
and hold in this position.
›
Switch on the ignition.
›
Hold the operating lever in this position for at least 3 seconds after switching
the ignition on.
The deactivation of the function is confirmed by an audible signal.
Activating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the indicator / main beam lever towards the steering wheel, push up and
hold in this position.
›
Switch on the ignition.
›
Hold the operating lever in this position for at least 3 seconds after switching
the ignition on.
The activation of the function is confirmed by an audible signal.
WARNING
When the daytime running light is switched on, the side lights (neither at
the front or rear) and the number plate lights are not lit. Therefore always
switch on the low beam when the visibility is poor.