Assembling The Bar Ball - 1. Step; Assembling The Bar Ball - 2. Step - Skoda Octavia Operating Instructions Manual

Operating lever is locked in the lower position.
 C
The trigger pin can be moved.
D

The ball bar is thus set ready for installation.
CAUTION
In the ready position, the key cannot be removed nor turned into a different
position.

Assembling the bar ball - 1. Step

Fig. 182 Insert ball rod / trigger bolt in the extended state

Read and observe and
Insert ball rod - applies to both key versions
›
Remove the cover for the mounting recess
downwards direction.
›
Adjust the ball rod to the ready position
›
Grip the tow bar from underneath
cess in arrow direction until you hear it click into place
1
The lever automatically turns upwards in the direction of arrow
A
release pin pops out (both its red and green parts are visible)
B
If lever does not turn automatically, or if the release pin
A
out, remove the ball rod from the mounting recess by turning lever
wards as far as it can go. Clean the contact surfaces on the ball rod and the
mounting recess.
168
Driving
on page 166 first.
» Fig. 178 on page 166 in a
4
» page 167.
» Fig. 182 and insert into the mounting re-
» .
»
does not pop
B
WARNING
Keep your hands outside the lever's range of motion when attaching the
■
ball rod – risk of finger injuries!
Never attempt to pull the operating lever violently upwards to turn the
■
key. Doing so would mean the ball rod is not attached correctly!

Assembling the bar ball - 2. Step

Fig. 183 Lock lock: Key Version 1 / key Version 2
and the
2

Read and observe
.
Initially carry out the first step of the ball rod assembly
down-
A
Applies to the key version 1
›
Turn key in the direction of arrow
A
upwards » Fig. 183.
›
Remove the key in the direction of the arrow
Fig. 184
Place cap on the lock
and on page 166 first.
» page
so that the green marking is pointing
1
.
2
168.
