Figure 4-8 Removing The Keyboard Deck (Part 1) - Digital Equipment HiNote VP 500 Series Service Manual

FRU Replacement

Figure 4-8 Removing the Keyboard Deck (Part 1)

13. Remove the Keyboard Deck by releasing the catches as shown (Figure 4-9) and lift the
Keyboard deck off the system housing.
14. Disconnect the cable that goes to the System Suspend/Resume button assembly from the
motherboard.
15. Lay the Keyboard deck on the LCD assembly.
___________________________ CAUTION __________________________
Be careful no to damage the LCD cable assembly.
______________________________________________________________
15. Remove the DC-to-DC Converter Board by pulling it straight up off its connectors. The
DC-to-DC converter board is located to the right of the PCMCIA slots.
16. Remove the two screws that hold the LCD cable assembly in place. Note the location of
the ground wire (Figure 4-10).
17. Disconnect the LCD cable assembly from the Motherboard by lifting up on the cable
connector.
_____________________________ Note ____________________________
The metal shield surrounding the cable connector is not a part of the LCD cable
assembly.
______________________________________________________________
4–10 Digital HiNote VP 500 Service Guide