FRU Replacement
Figure 4-6 Removing the CPU Daughter Card
Removing the LCD Assembly and Keyboard Deck
To remove the LCD Assembly:
1. Remove the Battery
2. Remove the FDD/CD Module or Secondary Battery
3. Remove the HDD Assembly (recommended)
4. Remove the Keyboard and Heatsink
5. As a part of this procedure you will remove the Keyboard Deck. Before starting, close
the LCD Assembly, turn the system unit over, and remove the screw located at the top of
battery compartment (Figure 4-9).
6. Open the LCD assembly and remove the left and right end caps by sliding them ¼ inch
toward the outside of the system unit and then up (Figure 4-7).
___________________________ CAUTION __________________________
On systems with IR support, the IR receiver/transmitter assembly is located under
the right end cap. Care should be taken when removing the right end cap.
______________________________________________________________
7. Remove the screw located under the right end cap. On systems with an IR
receiver/transmitter you will have to move the IR board to access the screw.
8. Remove the four hinge screws.
4–8 Digital HiNote VP 500 Service Guide