Sony PDW-F800 Operation Manual page 149

Settings on the PDW-HD1500
Item
Item M50: DHCP in the
Maintenance menu
Item M59: UPnP in the
Maintenance menu
3
Power both units off and on again, and
wait for about three minutes.
4
Check that the IP addresses of the two
units have been set as follows by the
Auto-IP function.
IP address of this unit
Item
NETWORK IP
page of ADDRESS
MAINTEN
ANCE
menu
IP address of the PDW-HD1500
Item
Item M51: IP
ADDRESS PRESET in
the Maintenance menu
5
In the clip list thumbnail screen of this
unit, select the clip to copy (upload).
6
Display the Thumbnail Menu.
7
Select Upload Clips via Direct FTP, and
then press the SET/S.SEL button or the
MENU knob.
With , selected, the Select Transfer Type
screen of the Upload Clips via Direct FTP
command appears.
8
Press the SET/S.SEL button or the
MENU knob.
The Select Remote Host screen appears.
9
Select "Hosts Discovered via UPnP",
and then press the SET/S.SEL button or
the MENU knob.
The detected connection destination device
(the PDW-HD1500) appears in the Select
Host Discovered via UPnP screen.
10
Press the SET/S.SEL button or the
MENU knob.
Setting
ENABLE
ENABLE
Setting
169.254.XXX.
XXX
(X: any number)
Setting
169.254.XXX.XXX
(X: any number)
Detailed information about the connection
destination device (the PDW-HD1500)
appears.
11
With "Connect" selected, press the
SET/S.SEL button or the MENU knob.
Transfer of the clip begins as soon as the
connection is established.
During transfer of the clip, "NETWORK!"
appears in the display of the connection
destination device (the PDW-HD1500).
When transfer of the clip completes, an
Uploading Result Report appears on the
screen.
Press the SET/S.SEL button or the MENU
knob to return to the clip thumbnail screen.
12
Check the copied clip in the clip
thumbnail screen of the connection
destination device (the PDW-HD1500).
Transferring clips (Direct FTP function) 149