Led Status Indicators; Projection Lens; Security Locks; Input Panel - Christie CP4220 Setup Manual

Lamp Door and Lamps
Provides access to the lamp. The lamp door must remain closed and locked for normal operation. Lamp
replacement should only be performed by qualified technicians.
The projector 7kW ballast is designed to operate with 2.0kW, 3.0kW, 4.5kW or 6.0kW lamps. See
the Lamp for a complete list of available lamp

LED Status Indicators

Provides information about the status of the projector. See Section 5 Operation for information about projector
status
Motorized Auxiliary Lens Mount (MALM)
An optional auxiliary lens mount can be installed adjacent to the primary lens mount to provide motorized
positioning of a 1.25x Anamorphic lens or a 1.26 Wide Converter lens in front of the primary lens. The Wide
Converter lens "zooms" the image from flat to scope image formats. The Anamorphic lens horizontally
spreads the image back into its wider 2.39:1 "scope" image and is most typically used in side-masking theatres
or on larger screen sizes.

Projection Lens

A variety of lenses can be used with the CP4220 projector. See
lenses.
RS-422 Connector
Connects the motorized lens mount to the projector.

Security Locks

Prevents unauthorized access to projector components.
Shroud
Covers the motorized lens mount assembly. The shroud is to be removed for installing a lens, MALM or when
using some 3D equipment.

Input Panel

Connects the projector to external devices.
PIB (Projector Intelligence Board) Faceplate Connections:
10Base-T/100Base-TX Ethernet: Connects the projector to a network.
GPIO: Connects the projector to external Input and output devices, such as the Christie ACT. See
3: Connect Devices to the Projector
DVI-A / DVI-B: Connects the projector to non-cinema video and graphics sources. These are single-link
ports for single-link cables and connectors. The connectors can be used together as a twin-link DVI port.
HD-SDI A/HD-SDI-B: Connects the projector to high-definition cinema sources. The connectors can be
used together to deliver Dual Link HD-SDI following the SMPTE 372M standard.
CP4220 Setup Guide
020-100692-02 Rev. 2 (05-2014)
types.
6.13 Replace the Lens
for GPIO pinouts.
Installation and Setup
6.9 Replace
for a list of available
Section
2-3