Contacting Your Dealer - Christie CP4220 Setup Manual

lamp is on. Wait a minimum of 10 minutes after the lamp turns OFF
disconnecting it from a power source, and opening the lamp door.
The arc lamp operates at a high pressure that increases with temperature. Failure to allow the lamp to
sufficiently cool prior to handling increases the potential for an explosion causing personal injury or
property damage.
1.4

Contacting Your Dealer

If you encounter a problem with your Christie projector, contact your dealer. To assist with the servicing of
your projector, enter the information in the tables and keep this information with your records.
Table 1.1 Purchase Record
Dealer:
Dealer or Christie Sales/Service Contact Phone Number:
Projector Serial Number*:
Purchase Date:
Installation Date:
* The serial number is on the license label located on the front panel of the projector.
Table 1.2 Ethernet Settings
Default Gateway
Projector IP Address
Subnet Mask
CP4220 Setup Guide
020-100692-02 Rev. 2 (05-2014)
Introduction
before
turning the projector off,
1-3