Member's Mark 720-0778C Assembly & Operating Manual page 15

Step 5: Side Burner Knob Assembly
5a) Loosen but do not remove screws on side
burner valve, insert valve stem into side burner
bezel gourd holes, the bezel are preassemble on
the side shelf front panel. Slide these 2 screws
into gourd hole error part, then tighten.
5b) Revolve the knob 90 degree along the
Igniter direction.
5c) Insert the Allen wrench into the hole and
into the set screw, positioned for tightening.
See Fig. 12.
Step 6: Battery Assembly and LED
light operation
Unscrew the electronic igniter button and
place the battery (J) into the housing with
positive terminal (+) facing outward. Replace
the ignition button after the battery has been
installed. See Fig. 13.
Assembly Instruction
Fig. 12
Fig. 13
J
15
continued