Interfaces - Wan 1 - D-Link DRO-250i User Manual

Configuring DRO-250i
3.2.2

INTERFACES - WAN 1

For WAN1 settings Click on Interfaces > WAN1 and the web page opens
as shown below:
User will need to enter the IP address, subnet mask, gateway address and
DNS address(es) provided to user by ISP. Each IP address entered in the
fields must be in the appropriate IP form, which is four IP octets separated
by a dot (x.x.x.x). The Router will not accept the IP address if it is not in
this format.
Protocol: CiscoHDLC/Sync PPP user can select the sync protocol which
can be either cisco HDLC or Sync PPP. User should confirm the protocol
supported by the ISP and then configure accordingly.
DRO-250i User Manual
22