Table of Contents
Advertisement
Configuring DRO-250i
Max:
At this average queue size, the marking probability is maximal.
Probability:
Maximum probability for marking, specified as a floating point number
from 0.0 to 1.0. Suggested values are 0.01 or 0.02 (1 or 2%, respectively).
Limit:
Hard limit on the real (not average) queue size in bytes. Further packets
are dropped. Should be set 8 * <max>.
Burst:
Used for determining how fast the average queue size is influenced by the
real queue size. Recommended: <burst> = (2 * <min> + <max>) / (3 *
<avpkt>).
Average Packet Size:
Specified in bytes. Used with burst to determine the time constant for
average queue size calculations.
Bandwidth:
This rate is used for calculating the average queue size after some idle
time.
e.g. User can enter the values like limit as 256000 min as 12000, max as
32000 average packet as 1000 burst as 20, probability as 0.02 and
bandwidth as 512. These values are just to give an idea to the user, so that
user does not enter any wrong range of values.
DRO-250i User Manual
98
Advertisement
Table of Contents
