Enabling The Network Connection To The Panel; Setting The Node Number; Setting The Printer - Faraday MPC-6000 Programming Manual

M P C - 6 0 0 0 / M P C - 7 0 0 0

Enabling the Network Connection to the Panel

This setting is used when the control panel is to be connected to a network. The
networking communications in the panel must be enabled as follows:
Action
1. Select "Edit".
2. Select "Manual Pgm".
3. Press "Cmor" twice to select "Network Setup".
4. Select "1" to install the network or "0" to remove
the network setting.

Setting the Node Number

If the panel is networked, it must have its network node number set as follows:
Action
1. Select "Edit".
2. Select "Manual Pgm".
3. Press "Cmor" twice to select "Network Setup".
4. Select "Dnxt". Type in the Node number.
5. Select "Dnxt" to continue to next setting or
"Bsav" to save the setting.

Setting the Printer*

If the printing of events from this node printer is required on the network, then it must be
set as follows:
Action
1. Select "Edit".
2. Select "Manual Pgm".
3. Press "Cmor" twice to select "Network Setup".
4. Select "Dnxt".
5. Select "Dnxt".
6. To Print Events for the node, select "1" for yes or
"0" for no.
7. Select "Dnxt" to continue to next setting or
"Bsav" to save the setting.
*For an MPC-6000 / MPC-7000, the default setting for the printer is OFF (Diagnostics test only).
For an RND-2, the default setting for the printer is ON.
/ R N D - 2 P R O G R A M M I N G
Result
When "1" is selected, Dnxt appears so other
network settings can be made.
Result
Be certain to enter leading zeros for nodes 1-9.
A maximum of 99 nodes can be entered.
When "Dnxt" is selected, the screen for the
printer setting displays. When "Bsav" is
selected, the Network Connection screen
displays.
Result
When "Dnxt" is selected, the screen for the
Total Number of Nodes displays. When "Bsav"
is selected, the Network Connection screen
displays.
38
M A N U A L