Operating Mode - Honeywell SDC Service Manual

Operation
5.2.3.3
Setting range
Set values
Factory setting
5.2.3.3.1
Setting
Setting range
Factory setting
74

Operating mode

Two operating modes can be selected. They determine whether
the operating mode, the daytime temperature and the night-time
temperature apply for all heating circuits or can be specified
individually for each heating circuit.
1, 2
1 The selected setting applies for all heating circuits together.
2 Each heating circuit can be assigned an individualised set-
ting.
1
Individualised daytime room temperature for each heating
circuit
► Press

button.
► Select desired heating circuit (HC, MC-1 or MC-2) by turning
the input button
► Confirm selected circuit by pressing the input button
► Set flashing room temperature specification to the desired
value by turning the input button
► Confirm set value by pressing the
Alternative: Automatic acceptance of the value after the set
information time (see 5.1.2.7 "System information" button, pg. 35).
5 ... 30 °C
20 °C

.

.

SDC / DHC

.
button.
EN2H-0221GE51 R0812