Honeywell SDC Service Manual page 37

SDC / DHC
Setting time for
automatic return
Setting range
Factory setting
5.1.2.7.1
Information
Outside
temperature (1)
Outside
temperature (1)
Outside
temperature (2)
Outside
temperature (2)
EM-SET (energy
management
setpoint)
Heat generator
temperature (1)
Heat generator
temperature (2)
EN2H-0221GE51 R0812

If the button is pressed and held for approx. 3 s, the INFO
TIME parameter appears.
With this parameter, the time it takes for automatic return to the
basic display can be specified.
OFF
1 ... 10 min
OFF
Temperature displays
Display Condition
Determined
value/Current
value
Min./max. value Outside sensor
(0:00 to 24:00 connected and no fault
hours) message
Determined Variable input
configured as OS2
value/Current
value
Min./max. value OS2 connected, no fault
(0:00 to 24:00 message
hours)
"EM-SET"
Setpoint/Actual Heat generator
value specified
Setpoint/Actual Variable input
value configured as BS2
No return. The last selected information display
continuously remains in the basic display until the
next change.
Automatic return from the information level after the
specified time (in 0.5 minute increments).
Remarks
Connection OS2 to variable
input VI1, VI2 or VI3
Highest hot-water setpoint
and highest heating circuit
setpoint in the system
Code 1 only appears if BS2
is present
Connection BS2 to variable
input VI1, VI2 or VI3
Operation
37