Honeywell SDC Service Manual page 260

Index
Return interval, 156
Return temperature, 147, 149
Room connection, 170
Room factor, 171
Room frost protection limit, 178
Room influence, 170
Room sensor, 170, 171
Room setpoint ramp, 176
Room thermostat function, 182
S
Screed function, 166
Selection level, 48, 54, 59, 61, 71
Selection of parameter presettings, 119
Sensor calibration, 251
Solar
Anti-blocking protection, 201
Collector maximum temperature limit,
198
Function, 198
Heat balancing, 200
Heat capacity, 201
Heat generator cycle disable, 199
Minimum runtime of loading pump SOP,
198
Priority mode, 199
Priority/parallel switch-over, 200
Resetting heat balancing, 200, 201
Switch-off differential, 198
Switch-on differential, 198
Tank maximum temperature limit, 199
Solid fuel
260
Function, 214
Solid fuel
Minimum temperature, 214
Solid fuel
Maximum temperature, 215
Solid fuel
Switch-on differential, 215
Solid fuel
Switch-off differential, 215
Solid fuel
Anti-blocking protection of solid-fuel
pump, 215
Summer switch-off, 123
Switching differential I, 132
Switching differential II, 132
Switching times, 73
Switch-off optimisation, 172
Switch-on optimisation, 172, 174, 175
System frost protection, 124
T
Tank discharge protection, 192
Tank loading switch-over, 215
Tank sensor 2, 193
Temperature displays, 37
Temperature limit, 165
Temperature measurement, 189
Temperature offset, 166
Time delay stage II, 134
Timer, 219
Total flow sensor, 227
V
Variable inputs and outputs, 114, 119
EN2H-0221GE51 R0812
SDC / DHC